Forum
TF2 Pickup [mIRC] Help
Created 25th March 2009 @ 22:10
Add A Reply Pages: 1
Hello all, new too the ETF2L Forums so I say hello.
Okay, I’m pretty new to TF2, moving over from CSS. The mIRC channel I got told about where pugs happen is on; mpuktf2.pickup
1. I have reigsterd an account onto Quakenet homepage
2. I have authorised my account on Quakenet
3. I am in the channel
But my problem is this: #mpuktf2.pickup Cannot send to channel
Now does this mean Im not 100% logged into Quakenet? – I don’t know.
Any help is appreciated.
Gravy.
Well, I done the AUTH command, and it says im logged in ________ (username)
I noticed for the pick-up you need to have played 20hours off each class before I join, for experience Im guessing.
Since I’ve not done this, this might be the reason Im not able too join/play?
/msg [email protected] AUTH nickname password
Yes I did that, and it says Im logged in.
But the rules say:
” A rule of thumb is to have at least 30 played hours and at least 20 hours in each of the classes you are going to play in pickups “#
As Im fairly new could this rule be stopping me?
Remember whenever you disconnect (or close mIRC) you are not authed anymore. So you have to auth every time you join the channel.
You are definitely not authed.
All i can think of is the auth command (did you put it in the right channel?)
/msg [email protected] auth [username] [password]
It will say in the mpuk channel that you are logged in if it works
make a perform script that does the auting for you.
in mirc:
tools>options; under the connect tab select servers; click perform;
check enable perform on connect; add quakenet to networks; select quakenet;
You can now put in the commands you wish to be run on connect eg. :
/msg [email protected] AUTH nick pwd
/join #mpuktf2.pickup
This will auth you on connect with quakenet and join the pickup chan. you can add extra lines to the perform for channels you’re in.
Add A Reply Pages: 1
content rss